1. The Axial shaft should be aligned before fixing the wire drum. Please measure the dimension refer to the (Fig. 3),
the measured values may not exceed the following dimension below.
2. The measured values ("X") are 0.5mm when the drum diameter is under 1,000 and 0.8mm if the drum diameter
is over 1,000mm.
3. The indicator and wear limit has to match with the same direction during the install and assemble as shown(Fig. 6).
4. And the coupling has to be fixed after the coupling adjusted the axis direction to bring ⓐ to match ⓑ as shown (Fig. 4).
5. To assemble the outer cover, it needs to have enough space ("Y") to fasten the bolts as following (Fig.5).
The values are (Table 1).
7. Fastening bolt and tigtening torque
It needs the torque wrench to fasten and to use the strength classification 8.8. The tightening torque will be as follow (Table 3).
